How Much Does Dishwasher Repair Cost in Cedar Rapids? (2026 Guide)
Quick Answer
Nationally, most dishwasher repairs cost about $100 to $300, and the average sits near $200 (Fixr, HomeAdvisor). A clog or a worn seal lands at the low end. A control board or motor lands at the high end. At Cedar Forge Appliance Repair we tell you the diagnostic fee before the visit and the full price before any work starts.
By the Cedar Forge Appliance Repair team. Last updated: October 2026.
A dishwasher that stops draining always seems to quit on the night the sink is already full. The first question is usually simple: is this an $80 fix or an $800 one? This guide gives you real price ranges, explains why two quotes for the same machine can be far apart, and helps you decide between repairing and replacing. When a number is a national figure, we say so. When it is ours, we say that too.
Dishwasher repair cost at a glance
Most homeowners pay between $100 and $300 for a dishwasher repair. HomeAdvisor reports a typical range of $160 to $300 with an average of about $200 (updated June 2026). Fixr lists $100 to $300 with the same $200 average and a full spread of $50 to $600 (January 2025). Angi gives $75 to $600 with an average of $225. These are national numbers, so treat them as a starting point and not as a Cedar Rapids quote.
| Repair | National price range | What usually causes it |
|---|---|---|
| Clogged filter or drain hose | $75 to $200 | Food debris, a kinked hose |
| Door gasket (seal) | $50 to $150 | Wear, leaking at the door |
| Spray arm | $75 to $100 | Cracked or blocked arm |
| Door latch | $75 to $250 | Dishwasher will not start |
| Heating element | $150 to $300 | Dishes come out wet or cold |
| Drain pump | $150 to $400 | Standing water after a cycle |
| Control board | $200 to $600 | Dead or erratic panel |
| Motor | $250 to $650 | Loud hum, no wash |
Ranges combine Angi, HomeAdvisor and local technician guides. Each is a national figure, checked October 2026. A diagnostic or service call fee is usually separate: HomeAdvisor lists it at $35 to $100 and Angi at $50 to $80.
What makes a dishwasher repair cost more or less?
Five things move the price: the part, the labor, the brand, the age of the machine, and whether a warranty applies.
The part. A drain pump or control board costs far more than a gasket, and that gap explains most of the spread in the table above. Parts for older models can also cost more because they are harder to find.
The labor. National labor rates run about $75 to $125 per hour. A hose you can reach takes minutes. A pump behind the kick plate of a tightly built-in unit takes longer, and the bill follows.
The brand. Parts for Bosch, Miele and KitchenAid often cost more than parts for Whirlpool, GE or Frigidaire. Samsung and LG sit in between. Premium brands also tend to last longer, which can justify a bigger repair.
The age. Past eight to ten years, parts get scarcer and a second failure becomes more likely. Age matters more to the repair-or-replace decision than to the repair price.
The warranty. Check for manufacturer coverage or a home warranty before you pay anyone. A repair that looks expensive can cost nothing if the machine is still covered.
How Cedar Forge prices a dishwasher repair
We tell you the diagnostic fee when you book, so it never turns up as a surprise at the door. The fee is $50, at the low end of the $50 to $80 range Angi reports nationally. It covers the technician’s time finding the fault. If you decide not to go ahead with the repair, the fee still applies because the diagnostic work was done.
Once the technician knows what failed, you get the full price for parts and labor before any work starts, and you can say no. Parts carry Iowa sales tax. Our repair guarantee has the details on what happens after the work is done. A final quote depends on the model and the fault, so every range in this guide is a guide and not a promise.
The same approach applies to every appliance we repair. Our appliance repair cost guide explains it in full.
What does dishwasher repair cost by problem?
Not draining. Nationally, HomeAdvisor lists $50 to $400 and other guides land around $100 to $350. A clog you clear yourself costs nothing. A failed drain pump runs $150 to $400 with parts and labor. If water keeps coming back after you clean the filter, the pump is the likely cause.
Leaking. A worn door gasket is the cheap answer at $50 to $150. A leak from underneath is different. It can be a hose, a pump seal or a cracked tub, and the range is wider.
Not starting. A faulty door latch is common and runs $75 to $250. If the panel is dead or flashes an error code, the control board is the likely cause at $200 to $600.
Not cleaning. Check the spray arms and the filter first. A cracked arm costs $75 to $100. If the water never gets hot, suspect the heating element at $150 to $300.
Loud noise or no wash. A grinding or humming sound often means a failed motor or circulation pump. That repair costs $250 to $650 and often settles the repair-or-replace question.
Should you repair or replace a dishwasher?
If the repair costs about half the price of a comparable new dishwasher, replacing usually wins. A new unit runs roughly $400 to $1,300 nationally, and with installation a mid-range model often totals $1,000 to $1,500. For an entry-level machine, that puts the line near $200 to $300 of repair cost, and higher for a premium one.
Age settles the close calls. Dishwashers last about 9 to 12 years on average. Under five to seven years, one failed part is almost always worth fixing. Past ten years, a $300 pump on a machine that already cleans poorly buys you time toward the next failure. Premium brands such as Bosch and Miele often run 10 to 15 years or more, so a mid-life repair on one makes more sense than on a builder-grade unit.
Repair when the machine is under seven years old, one part has failed, and the tub has no rust or active leak. Replace when it is over ten years old, the fault is a motor or control board, or this is the second big repair in two years. Daily use and hard water wear a dishwasher faster than the calendar suggests. Our repair or replace guide walks through the same decision for every appliance.
Can you fix it yourself first?
Three free checks can save you the call. First, pull the bottom rack and clean the filter, which catches food and clogs easily. Second, run the sink disposal or clear the knockout plug if the dishwasher drains through it. Third, check that the drain hose is not kinked behind the machine. If water still sits in the tub after that, stop and call a technician, because the pump is the likely cause. Switch off the power before you pull the machine forward, and never open the control panel or touch wiring with the power on.
What affects dishwasher repair in Cedar Rapids homes?
If your water is hard, as it is across much of Iowa, mineral scale builds up on heating elements and inside pumps over time. A monthly cycle with a dishwasher cleaner slows that down. Older kitchens with tight cabinet fits add labor when a unit has to be pulled out. We serve Cedar Rapids, Marion, Hiawatha, Robins and Fairfax.
Who should you call for a dishwasher repair?
Call an appliance technician when the machine itself fails: it will not drain, start, heat or clean. Call a plumber when the problem is in the home’s supply line or drain pipe, for example a shutoff valve that will not close or a sink drain that backs up into the tub. For most dishwasher faults, an appliance technician is the right first call. You can book dishwasher repair in Cedar Rapids directly with us.
Dishwasher Repair Cost FAQ
What is the average cost to repair a dishwasher?
Is it worth paying to fix a dishwasher?
How much does it cost to repair a dishwasher that isn't draining?
How long does a dishwasher last?
Is it cheaper to fix or buy a new dishwasher?
Is the diagnostic fee deducted from the repair cost?
Can a plumber fix a dishwasher?
Does a warranty cover dishwasher repairs?
Need a Dishwasher Repaired in Cedar Rapids?
Call Cedar Forge Appliance Repair at (319) 432-7410. We serve Cedar Rapids, Marion, Hiawatha, Robins and Fairfax, offer same-day service when the schedule allows, and give you the price before any work starts.



